When I began learning about milling wood, I always heard to mill in two sessions at least a day apart, in case the wood moves at all. Glad I remembered that, this was after one session a few weeks ago.
6 thoughts on “Mill Boards In Two Sessions”
Out of curiosity, how long did the wood sit in your shop before you did the initial milling?
Hi John, If I understand you correctly, yes. I jointed one face, then one edge. Then to the thickness planer to mill the other face parallel to the first, then over to the table saw to rip the last edge parallel to the first. When I was done, I did sticker them.
The one thing I can think of is that when I milled them, the shop humidity was ~60%, and when I took that picture, it was probably down to about 30%. With the rain we’ve had recently, the shop is back up to about 50%, so might take another look at it tonight when I get home from work…
Hi John, I did get to check the board. Still cupped, but not quite as much. I didn’t mill again though as I was focused on a shop organization project last few weekends. Hopefully this coming weekend I can go through the next milling session.
Out of curiosity, how long did the wood sit in your shop before you did the initial milling?
Hi Matt, the boards were in the shop about 6 weeks before I started to mill them.
wow, that’s quite a cup. Did you mill evenly from both sides? were the boards stickered afater the initial milling?
Hi John, If I understand you correctly, yes. I jointed one face, then one edge. Then to the thickness planer to mill the other face parallel to the first, then over to the table saw to rip the last edge parallel to the first. When I was done, I did sticker them.
The one thing I can think of is that when I milled them, the shop humidity was ~60%, and when I took that picture, it was probably down to about 30%. With the rain we’ve had recently, the shop is back up to about 50%, so might take another look at it tonight when I get home from work…
Hey Jim, how’d you make out with this?
Hi John, I did get to check the board. Still cupped, but not quite as much. I didn’t mill again though as I was focused on a shop organization project last few weekends. Hopefully this coming weekend I can go through the next milling session.